Shield Arduino Micro RGB
Shield for Arduino Micro with management of a 24V RGB LEDs strip (not included). Simplifies wiring and connections!
There is a normal version without the management of the RGB LEDs strip: Shield Arduino Micro
This shield is designed for Arduino Micro with the codes I wrote (1.81 Leds). It simplifies the wiring and connections of Sabertooths and potentiometers. No need to make bridges for ground and 5V, just connect the wires of the shielded cable directly and tighten them using a small flat screwdriver.
In addition, you have easier access to the possibility of adding a general power potentiometer as well as a switch to force the simulator in the stand-by position (defined in the config.h file)
You might also like